Please wait, I'm coming over...
 |
|
|
Last Changed 2/11/2007 |
||
|
One wiring trunk distributed from the
Electrical Compartment is the wiring for the Bed. |
||
 |
I did the bed wiring. I connected the harness off the signal distribution terminal strip located in a junction box under the headache rack cabinet. I used 2" junction boxes with reducers to 1 ΒΌ. This fits the 1" plastic wire looms that I used for the wire. | |
 |
I chose terminal strips instead of soldered connections to simplify maintenance in the future. Ideally this should be a one time task but I had to disconnect the headache to have the bed build. Having terminal strips was a lot easier that cutting solder connections. | |
click on images to enlarge |
||
Disclaimer: The information in this site is a collection of data we derived from the vendors and from our personal experiences. This information is meant as a learning guide for you to make your own decisions Best practices and code should always be followed. The recommendations we make are from our personal experiences and we do not receive any compensation for those recommendations. |